Removing The Mechanical Covers; Removing The Backplane System Board Mounting Screws - HP rp3440 Service Manual

• Memory (DIMMs). (See
• Dual processor modules. (See
• iLO MP card. (See
4. Remove the mechanical covers that are covering the VGA and DB9 ports.
Figure 6-64 Removing the Mechanical Covers
5. Unscrew the six backplane system board mounting screws that connect the system board
to the rear of the server chassis.
Figure 6-65 Removing the Backplane System Board Mounting Screws
6. Disconnect the AC power cable connectors.
7. Disconnect all cables that are connected to the system board. To help with re-assembly, make
note of which cables were connected to which connector.
8. Lift the fan bridge to access the three power cables near the PCI card cage.
9. Unscrew the system board mounting screw. A screw symbol is adjacent to the mounting
screw.
178 Removing and Replacing Components
"Removing System Memory" (page
"Removing a Dual Processor Module" (page
"Removing the iLO MP Card" (page
152))
155))
173))