Replacing The Ilo Mp Card; Removing The Ilo Mp Card - HP rp3440 Service Manual

4. Disconnect all the power and external cables.
5. Remove the top cover. (See
6. Unscrew the two mounting screws that connect the iLO MP card to the internal chassis post
and the two external mounting screws that are located on both sides of the 25-pin serial
connector.
Figure 6-61 Removing the iLO MP card
7. Disconnect the iLO MP card connector.
8. Remove the iLO MP card from the server by grasping it by its edges

Replacing the iLO MP Card

To replace the iLO MP card, follow these steps:
1. Insert the iLO MP card in the server by grasping its edges and placing it on the two iLO MP
card posts.
2. Push the 10/100 management LAN, 15-pin VGA and 25-pin serial connectors through their
openings on the back of the server.
3. Connect the iLO MP card:
a. Connect the iLO MP card cable to its connector on the system board.
b. Insert and tighten the two mounting screws that connect the iLO MP card to the internal
chassis post.
c. Insert and tighten the two external mounting screws that are located on both sides of
the 25-pin serial connector.
4. Replace the top cover.
5. Reconnect the power and external cables. (Do not turn on the server at this time.)
6. If you have installed a new iLO MP card, use the iLO MP commands to configure the server
for operation. Enter the network settings recorded during iLO MP card removal (if available).
174 Removing and Replacing Components
"Removing and Replacing Server Covers and Bezel" (page 126).)
(Figure 6-61).