Power Cables And Holding Clips; Removing The Power Supply Interface Module; Replacing The Power Supply Interface Module - HP Integrity rx2600 Operation And Maintenance Manual

Removing the Power Supply Interface
To remove the power supply interface module, follow these steps:
1. Power off the server, disconnect all power and external cables, and remove the server covers.
2. Remove the system board.
3. Lift the power cables out of their metal holding clips.

Power Cables and Holding Clips

4. Unscrew the PSI mounting screw and remove the PSI module from the server.
1

Removing the Power Supply Interface Module

1 Remove Mounting Screw
2
Slide PSI out of Chassis
3 PSI Removed from Server

Replacing the Power Supply Interface Module

To replace the power supply interface module, follow these steps:
1. Place the PSI module into the chassis by sliding the module retaining tab into the slot on the
hard disk drive bay wall.
HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
2
Removing and Replacing Components
3
105