Removing And Replacing The Power Supply Interface Module; Removing The Power Supply Interface Module - HP 9000 rp3410 User's & Service Manual

Step 6. When prompted, enter the product number located on the pull-out tag. Confirm by answering Y
when asked. If you made a mistake entering the product number, you can answer N and re-enter
the product number when asked.
Step 7. Enter the system serial number when prompted. If you accidentally hit return without entering the
system serial number, you will have a default value. Confirm the original serial number by entering
Y when asked. If you made a mistake entering the serial number, you can answer N and re-enter the
serial number when asked.
Step 8. If your product is a one processor 800MHz CPU, skip steps 9-12 and go to step 13 to reset your
server.
Step 9. At the service menu prompt, enter upgrade. The system will ask you for the system serial number.
Step 10. Enter the system serial number from the pull-out tag.
Step 11. Enter the key from the key certificate that is on the back side of the pull-out tag. The key certificate
number and system serial number are a pair and must be used together. If you do not enter the
correct key certificate number, the server components will not be functional.
Step 12. The screen displays the current system value (rp3410 dc--) and the original upgraded system value.
You will be prompted with the question "Do you wish to continue with this change?" Answer Y to
confirm the change.
Step 13. Enter reset to reboot the server. perform the resetting with the changes in effect.
Step 14. Perform the resetting with the changes in effect.
CAUTION If this procedure is not followed, the server components will not be functional.

Removing and Replacing the Power Supply Interface Module

The Power Supply Interface (PSI) module supports up to two redundant power supplies.

Removing the Power Supply Interface Module

Step 1. Power off the server and disconnect all power and external cables.
Step 2. Remove the top cover. (See "Removing and Replacing Server Covers and Bezel" on page 151.)
Step 3. Remove the system board. (See "Removing the System Board" on page 214.)
Chapter 6
Removing and Replacing Components

Removing and Replacing the Power Supply Interface Module

223