Removing and Replacing Internal Components
To upgrade, remove, or replace most server components, you must first shut down
the server, and remove the top metal cover.
WARNING!
and unplugging the power cord from the outlet or power protection device unless you
are replacing a hot-swappable fan.
When the server is running, you must replace the top metal cover within 30 minutes
to prevent components from overheating. If the top metal cover is not replaced within
30 minutes, the server automatically shuts down. If the server shuts down, always
replace the covers before turning the server back on.
Memory and Processor Airflow Guides
The server has the following airflow guides:
The processor airflow guide. See
The memory airflow guide. See
Air flows through the server from front to back.
Figure 32 Airflow Guides Locations
Removing and Replacing the Memory Airflow Guide
The following procedures explain how to remove and replace the memory airflow
guide.
Removing the Memory Airflow Guide
1.
Power off the server and disconnect all power cables. See
Server" (page
2.
Remove the top metal cover. See
3.
Grasp the memory airflow guide and lift it out of the server. See
Do not remove the server covers without first powering the server off
27).
Figure 32
Figure 32
"Removing the Top Metal Cover" (page
"Powering Off the
33).
Figure
33.
43