Diagnostic Aids; Customer Test Page (From Wps); Customer Test Page (Stand Alone); Developed Image Test - Lexmark Optra E 4026-0 Series Reference Handbook

Diagnostic Aids

Customer Test Page (From WPS)

Use this test to check print and graphics quality. Running the print test
resets temporary settings to the printer default settings and deletes all
macros and downloaded fonts.
To run the Print Test:
1. Turn the printer on.
2. Select [Test Printer] from the WPS Setup Screen in Print
Manager.
3. One test page prints.
The printer returns to the default settings after the test page prints.

Customer Test Page (Stand Alone)

Use this test to check print and graphics quality. Running the print test
resets temporary settings to the printer default settings and deletes all
macros and down-loaded fonts.
To run the Print Test:
1. Open the top cover.
2. Turn the printer on.
3. After the printer status light starts blinking, close the top cover.
4. One test page prints after POST completes.
The printer returns to the default settings after the test page prints.

Developed Image Test

This test allows you to examine the image on the photoconductor and
may be used to diagnose print quality problems. You may need to do
this procedure several times to get the timing correct.
To run the Developed Image Test:
1. Run the Customer Test Page (Stand Alone).
2. Turn the printer off while it is printing.
3. Remove the print cartridge and look at the image on the
photoconductor.
2-10
Laser Printer Reference Handbook