Matrix Dfe Startup Screen Example (N7 Chassis); Completing The Installation Of A Dfe Module In An Existing System; Logging In With An Administratively-Configured User Account - Enterasys Matrix 7GR4202-30 Hardware Installation Manual

Completing the Installation
Figure 3-18

Completing the Installation of a DFE Module in an Existing System

In an established DFE module system,
• a DFE module is already established as the management module,
• the passwords have already been set for various users,
• the system IP address is set, and
• other system parameters have been set.
When you install a new DFE module into a system with an existing configured user account, the
current system settings in that account are already recognized by the new DFE module and it will
operate accordingly.
If you need to change any settings, you can connect a terminal to the local console port as
described in "Connecting to COM Port for Local Management" on page 3‐20 to access system
management, or use a Telnet connection to access the DFE module system management as
described in the Enterasys Matrix DFE‐Diamond/Platinum Series Configuration Guide.

Logging in with an Administratively-Configured User Account

If the device's default user account settings have been changed, proceed as follows:
1. At the login prompt, enter your administratively‐assigned user name and press ENTER.
2. At the Password prompt, enter your password and press ENTER.
The notice of authorization and the Matrix prompt displays as shown in Figure
3-26 Installation

Matrix DFE Startup Screen Example (N7 Chassis)

login: admin
Password:
M A T R I X N7
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2003
Chassis Serial Number:
Chassis Firmware Revision: xx.xx.xx
Matrix N7(su)->
Note: Users with Read-Write (rw) and Read-Only (ro) access can use the set password
command to change their own passwords. Administrators with Super User (su) access can use
the set system login command to create and change user accounts, and the set password
command to change any local account password. For information on the set password and set
system login commands, refer to the Enterasys Matrix DFE-Diamond/Platinum Series
.
Configuration Guide
xxxxxxxxxxxx
3‐18 on page 3‐26.