Using The Machine Ftp Server For Association; Overview; Configuring The Ftp Server Settings - Konica Minolta bizhub C754 User Manual

16.3

Using the machine FTP server for association

16.3 Using the machine FTP server for association

Overview

To use application software with which the FTP server of this machine is used to communicate, configure the
FTP server.
To use the FTP server of this machine for the association, follow the below procedure to configure the set-
tings.
1
Configure settings for connecting to the network such as setting of the IP address of this machine
% For details on configuring the setting, refer to page 2-2.
2
Configure the FTP server settings
% For details on configuring the setting, refer to page 16-7.

Configuring the FTP server settings

Enable the FTP server. Configure the security relevant settings.
In the administrator mode, select [Network] - [FTP Setting] - [FTP Server Setting], then configure the following
settings.
Settings
[FTP Server]
[Deny Reception Com-
mand]
[PORT Command En-
hanced Security]
bizhub C754/C654
Description
Select [ON] to use the FTP server.
[ON] is specified by default.
Select a command to deny a receiving job from an FTP client when using
the FTP server of this machine.
Set this option to return an error when a PORT/EPRT command or
PASV/EPSV command is sent from an FTP client to this machine.
[Allow] is specified by default.
Select whether to enable the security of this machine against FTP bounce
attacks. This option is not available if [Deny Reception Command] is set to
[PORT/EPRT].
When a PORT/EPRT command is sent from an FTP client, the data con-
nection is established only if both of the following conditions are satisfied:
• A port number less than 1024 is not specified.
• The IP address specified by the command is same as that specified
when a control connection is established.
[Enable] is specified by default.
16
16-7