Konica Minolta bizhub C754 User Manual page 304

14.6 Managing the machine via SNMP
Settings
[Write Community
Name]
[SNMP v3 Setting]
[Context Name]
[Discovery User
Name]
[Read User Name]
[Security Level]
[auth-password]
[priv-password]
[Write User Name]
[Security Level]
[auth-password]
[priv-password]
[Encryption Algorithm]
[Authentication Method]
[TRAP Setting]
[Allow Setting]
[Trap Setting when
Authentication Fails]
[Administrator Information]
[Device Name]
[Device Location]
[Administrator Name]
bizhub C754/C654
Description
Select this check box to allow read and write. Also enter a community
name used for reading and writing (using up to 15 characters, excluding
spaces, \, ,' ,", and #).
When you use SNMP v3, configure the settings relevant to SNMP v3.
Enter the context name (using up to 63 characters, excluding spaces, \, ',
", and #).
Select this check box if you allow a user for detection. Enter a user name
for detection (using up to 32 characters, excluding spaces, \, ', ", and #).
Enter a read-only user name (using up to 32 characters, excluding spaces,
\, ,' ,", and #).
Select a security level for the read-only user.
If [auth-password] or [auth-password/priv-password] is selected from [Se-
curity Level], enter an authentication password for the read-only user (us-
ing between 8 to 32 characters, excluding spaces and \).
To enter (change) the password, select the [Password is changed.] check
box, then enter a new password.
If [auth-password/priv-password] is selected from [Security Level], enter a
password used for privacy (encryption) of the read-only user (using be-
tween 8 and 32 characters, excluding spaces, \, ', ", and #).
To enter (change) the password, select the [Password is changed.] check
box, then enter a new password.
Enter a user name used of the read and write user (using up to 32 charac-
ters, excluding spaces, \, ', ", and #).
Select a security level of the read and write user.
If [auth-password] or [auth-password/priv-password] is selected from [Se-
curity Level], enter an authentication password for the read and write user
(using between 8 and 32 characters, excluding spaces, \, ', ", and #).
To enter (change) the password, select the [Password is changed.] check
box, then enter a new password.
If [auth-password/priv-password] is selected from [Security Level], enter a
password used for privacy (encryption) of the read and write user (using
between 8 and 32 characters, excluding spaces, \, ', ", and #).
To enter (change) the password, select the [Password is changed.] check
box, then enter a new password.
Select an encryption algorithm.
Select an authentication method.
Set TRAP function to notify of the machine status using the SNMP TRAP
function.
Select [Allow] to use the SNMP TRAP function.
Select whether to send TRAP when authentication fails.
If necessary, enter the information of this machine.
Enter the name of this machine (MIB sysName) (using up to 255 charac-
ters).
Enter the location where to install this machine (MIB sysLocation) (using up
to 255 characters).
Enter the administrator name (MIB sysContact) (using up to 255 charac-
ters).
14
14-24