Using The Tsi Routing Function - Konica Minolta bizhub C754 User Manual

9.3 Specifying useful transmission and reception functions
Settings
[Receiving User Box Desti-
nation]
[Print]
[Communication Pass-
word]
9.3.7

Using the TSI Routing function

TSI (Transmitting Subscriber Identification) is a sender's fax number. TSI (Transmitting Subscriber Identifica-
tion) Routing is a function that automatically sorts incoming faxes into preset boxes or redirects them to user
computers or E-mail addresses based on the fax numbers of the senders (TSIs).
Tips
- This function cannot be used together with the following functions.
– Forward TX, Compulsory Memory RX, PC-Fax RX
- When using two lines, you can select, in the administrator mode [Fax Settings] - [TX/RX Settings] - [In-
dividual Receiving Line Setup] to use the TSI Routing function by line.
1
In the administrator mode, select [Fax Settings] - [Function Settings] - [RX Data Operation Settings] -
[TSI User Box Settings], then click [OK].
2
When using two lines, select the line for which the TSI Routing function is set, and click [Edit].
% If no additional line is connected, go to Step 3.
3
At [TSI User Box Settings], configure the following settings.
bizhub C754/C654
Description
Select the location where you want to a received fax saved from [Memory
RX User Box] or [Specified User Box] (a User Box specified in F-Code (SUB
Address)).
[Memory RX User Box] is specified by default.
Select whether to print a received fax after it has been received.
[ON] is specified by default.
If you select [Specified User Box] for [Receiving User Box Destination],
specify whether to check the communication password (Sender ID) for PC-
Fax reception.
To confirm the communication password, select the [Password Check]
check box, then enter a communication password (using up to eight digits).
9
9-15