Konica Minolta bizhub C754 User Manual page 250

12.19 Using the authentication unit
2
In the administrator mode, select [User Auth/Account Track] - [LDAP-IC Card Authentication Setting] -
[Server Registration] - [Edit], then register information of the LDAP server to be used for authenticating
the user ID of the IC card.
Settings
[Server Address]
[Port No.]
[Search Base]
[Timeout]
[General Settings]
bizhub C754/C654
Description
Enter the address of the LDAP server to be used for authenticating the user
ID of the IC card.
Use one of the following formats.
• Example of host name entry: "host.example.com"
• Example of IP address (IPv4) entry: "192.168.1.1"
• Example of IP address (IPv6) entry: "fe80::220:6bff:fe10:2f16"
If necessary, change the LDAP server port number.
Normally, you can use the original port number.
[389] is specified by default.
Specify the starting point to search for a user to be authenticated (using up
to 255 characters).
The range from the entered origin point, including the following tree struc-
ture, is searched.
Example of entry: "cn=users,dc=example,dc=com"
If necessary, change the time-out time to limit a communication with the
LDAP server.
[60] sec. is specified by default.
Select the authentication method to log in to the LDAP server.
Select one appropriate for the authentication method used for your LDAP
server.
• [Simple]
• [Digest-MD5]
• [GSS-SPNEGO]
• [NTLM v1]
• [NTLM v2]
[Simple] is specified by default.
12
12-65