Tx Mode Default - Oki OF5700 Service Manual

14 Remote diagnosis
15

TX mode default

16 No toner memory RX
17 Memory full save
18 Instant dial
Determine whether remote maintenance is to be enabled from the remote
center.
1) Setting values
ON (Enables)/OFF (Disables)
Set transmission mode default values used when a document is set in the
feeder.
The resolution and scanning density can be set sepa-rately.
1) Resolution
STANDARD/FINE/EXTRA FINE/PHOTO selectable
2) Scanning density (Type of Original)
LIGHT/NORMAL/DARK selectable
OKIFAX 5700/5900 Determine whether data is to be received in the memory
or on recording paper when the toner level is low.
1) Setting values
ON (Memory reception)/OFF (Recording paper reception)
ON: Data received in the memory when the toner level is low.
OFF: Data is received on recording paper if the toner level is low (the print
quality is poor because the toner level is low).
When the memory becomes full during read, the operator must determine
whether the read pages are to be saved or canceled. Determine whether the
read pages are to be saved or canceled automatically if the operator forget to
save/cancel them and therefore an operation T.O. results.
1) Setting values
ON (Saved)/OFF (Canceled)
ON: The page being read is discarded and the previously read pages are
saved (or transmitted if transmission preparation is specified).
OFF: All pages are discarded including the page being read.
Determine whether instant dial transmission is to be performed.
If the remaining memory capacity is not satisfied the instant dial start condition
although this setting is ON, the feeder transmission is performed. When this
setting is OFF, the feeder transmission is uniformly performed.
1) Setting values
ON (Instant dialing transmission is performed)/OFF
(Instant dialing transmission is not performed)