Table; Ip Address - Oki OF5700 Service Manual

2.9.5.7 Table

No. Item
80 Auto Tray Switch
81 Paper Size Check
82 LAN Print Timeout
83

IP Address

Service Guide OKIFAX 5700/5900
Specifications
Determine whether the current tray is automatically switched to another
tray when the current tray runs out of paper in the LAN print mode.
This setting can be made only when the second tray is installed.
1) Setting values
ON: Switched
OFF: Not switched
Determine whether the set paper size is to be checked against the
host-specified paper size in the LAN print mode.
1) Setting values
ON: Checked
OFF: Not checked
* If the two paper sizes do not match, the machine takes the following
action:
ON: Issues a paper request directly before starting printing and detects the
paper size and jam after starting printing.
OFF: Does not issues a paper request directly before starting printing nor
detect the paper size and jam after starting printing.
Set the time from job start to job end during which image data storage in
the image memory (from LAN) should be completed. If this time is expired,
LAN printing will be interrupted.
1) Setting values
5 sec/30 sec/5 min selectable
Display the IP address from the NIC, check the data from the terminal, and
change the setting.
1) Setting values
32 bits are divided into four 8-bit decimal values for setting.
The decimal values are separated by dots as shown below.
[206.181.233.105]
* If a LAN option is installed, this setting cannot be made when an HSP
error has occurred.
* This setting cannot be made when not supported by NIC card.
Chapter 2 Installation
Page: 138