2.9.5.4 Dial Options Table
No. Item
40
Redial tries
41
Redial Interval
42
Auto Start
43
Dial Tone Detect
44
Busy Tone Detect
45
MF/DP
Service Guide OKIFAX 5700/5900
Specifications
Sets on the redial tries to meet the regulations of the installed country.
1) Setting values
Country code =
Other than FRE: 0-10 (in one-try steps)
FRE: 1-5 (in one-tray steps)
Set an automatic redialing interval to meet the regulations of installed country.
1) Setting values
Country code =
Other than FRE: 1-6 (in one-minute steps)
FRE: 1-12 (in one-minute steps)
Determine whether a call is to be originated automatically without pressing the
START key after specifying a destination with a speed dial key.
1) Setting values
ON (Automatic origination)/OFF (Call is not originated until START key is
pressed)
Determine whether a dial tone is to be detected.
1) Setting values
ON (Detected)/OFF (Not detected)
* Selection is skipped over when the ISDN board is mounted.
(selection allowed if SERVICE BIT=ON)
Determine whether a busy tone is to be detected.
1) Setting values
ON (Detected)/OFF (Not detected)
* Selection is skipped over when the ISDN board is mounted.
(selection allowed if SERVICE BIT=ON)
Determine whether MF or DP is to be used for call origination.
1) Setting values
MF (Tone)/DP (Pulse)
* Selection is skipped over when the ISDN board is mounted.
(selection allowed if SERVICE BIT=ON)
Chapter 2 Installation
Page: 128