Cautions - Oki OF5700 Service Manual

Page: 361
Service Guide OKIFAX 5700/5900
Chapter E PC-Loading
3.3.1 Explanation of Procedure
The G4 board PC loading procedure is explained below assuming that the MFP system is normal.
1. With the host PC connected to the MFP (having a G4 board) through a Centro cable, turn on the PC and then
MFP.
2. Start MS(PC)-DOS on the PC, then perform the G4 board PC loading start key operation on the MFP. (Make sure
"PC-LOADING" is displayed on the LCD on the MFP system and the "Ready" buzzer sounds.)
3. Execute an MS(PC)-DOS command "COPY" along with a binary switch on the PC to output the G4 board PC
loading data file to the LPT1. Thus, the loading data can be transferred to the MFP.
Example: >copy/b xxx.x LPT1 (xxx.x is a loading file name.)
4. Look at the message on the LCD and listen to the "MFP normal end" buzzer to check that G4 board PC loading
has been competed normally. If the MFP displays an error code on the LCD, issues an error buzzer, or turns on an
alarm LED, power the MFP off and on again to perform the above steps again assuming that a PC loading error has
occurred.
Caution!
Even if a G4 board memory error or a G4 board flash memory contents error occurs together with a hash match error
(i.e., runaway), G4 board loading can be performed following the procedure mentioned above.
Copyright 1998, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business Partner
Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)