Tx Mode Default - Oki OKIFAX 5750 Service Manual

14 Remote diagnosis
15

TX mode default

16 No toner memory RX
17 Memory full save
18 Instant dial
English/Other
Other (second language): GER (German), FRE (French), etc.
* English/Other is selected according to country code.
Determine whether remote maintenance is to be enabled from the
remote center.
1) Setting values
ON (Enables)/OFF (Disables)
Set transmission mode default values used when a document is set in
the feeder.
The resolution and scanning density can be set sepa-rately.
1) Resolution
STANDARD/FINE/EXTRA FINE/PHOTO selectable
2) Scanning density (Type of Original)
LIGHT/NORMAL/DARK selectable
OKIFAX 5750/5950 Determine whether data is to be received in the
memory or on recording paper when the toner level is low.
1) Setting values
ON (Memory reception)/OFF (Recording paper reception)
ON: Data received in the memory when the toner level is low.
OFF: Data is received on recording paper if the toner level is low (the
print quality is poor because the toner level is low).
When the memory becomes full during read, the operator must
determine whether the read pages are to be saved or canceled.
Determine whether the read pages are to be saved or canceled
automatically if the operator forget to save/cancel them and therefore
an operation T.O. results.
1) Setting values
ON (Saved)/OFF (Canceled)
ON: The page being read is discarded and the previously read pages
are saved (or transmitted if transmission preparation is specified).
OFF: All pages are discarded including the page being read.
Determine whether instant dial transmission is to be performed.