Table 2.9.5.5 Incoming Options - Oki OF5700 Service Manual

Table 2.9.5.5 Incoming Options

No. Item
60 Incoming Ring
61 Remote Receive
Service Guide OKIFAX 5700/5900
Specifications
Set up the soft ringer.
Instead of ringer circuit, software can control built-in speaker to ring sound.
1) Setting values
ON (Sounded)/OFF (Not sounded)/DRC (Sounded during DRC detection)
* Selection is skipped over when the ISDN board is mounted.
(selection allowed if SERVICE BIT=ON)
* If DISTINCTIVE RING is settable, OFF/ON/DRC is selectable.
("Settable" means that SERVICE BIT is ON or mask by XPARA is not provided
with SERVICE BIT=OFF.)
* If DISTINCTIVE RING cannot be set, OFF or ON is selectable.
* Setting is possible if SERVICE BIT is ON even though masking is done by
XPARA. In this case, if SERVICE BIT is turned OFF with this setting set to
DRC, setting is changed from DRC to the default (i.e. initial value provided for
each default type).
* If COUNTRY CODE is USA, AUS, NZL, SIN or HNG, this setting is set to
DRC.
If COUNTRY CODE is changed to any other country, setting is changed from
DRC to the default.
Set a remote access address.
This function is used to transfer a call received by an external telephone set
(connected to fax) by entering two-digit MF tones if the remote receive setting
is not OFF.
When this function is off, control of Parallel Pick Up doesn't do it at all
regardless of ON/OFF of Parallel Pick Up setting.
1) Setting values
Select one of the following:
OFF/00/11/22/33/44/55/66/77/88/99/**/## selectable
* Selection is skipped over when the ISDN board is mounted.
(selection allowed if SERVICE BIT=ON)
Chapter 2 Installation
Page: 133