Buzzer Volume; Closed Network; Tx Mode Default; Telephone/Fax Automatic Switchover Time - Oki OF5600 Service Manual

P.F.
Item
No.
07

Buzzer volume

08

Closed network

09

TX mode default

10 Telephone/fax automatic
switchover time
Installation
User Function Program Settings (Table 2.9.4)
Part 2 of 4
Selects the sound volume of each buzzer (end of
communication buzzer, voice request buzzer and
off-hook alarm) and software ringer from high, low
and middle levels.
Low/Mid/High selectable.
Note: Fixed a low level for key touch tone.
The fax compares lower four digits of TSI/CSI
received from remote station with fax numbers
registered locally for one-touch dial and two-digits
autodial.
If unmatched, the communication will be automati-
cally disconnected.
OFF/RX only/TX and RX selectable.
* Prevention of direct mail or wrong number calls.
(Reference)
TSI: Transmitting subscriber identification
CSI: Called subscriber identification
Selects automatically the mode set up when a
document is loaded on the feeder.
The following combinations are selectable.
STD/NORMAL STD/DARK STD/LIGHT
FINE/NORMAL FINE/DARK FINE/LIGHT
EX.FINE/NORMAL EX.FINE/DARK
EX.FINE/LIGHT PHOTO/NORMAL
PHOTO/DARK PHOTO/LIGHT
STD/NORMAL
Specifies the time for which the fax alerts an
operator on reception of a call in the telephone/fax
automatic swichover mode.
20 sec./35 sec. selectable
Refer to the "Tel/Fax Mode Flowchart" in this
section.
2 - 61
Specifications
• • •
OKIFAX 5300/5600
Service Manual, P/N 59278301
Default
MID
OFF
STD /
NOR-
MAL
35 sec.