CHAPTER 7
Troubleshooting
Color balance is different between software and print
Problem
Did you use Gerber-approved
material?
Are you using the correct Gerber
color profiles for the material you are
using?
The printer pauses between passes
Problem
Does the printer pause at regular
intervals between passes?
Is the computer you are sending the
job from performing other tasks?
Are all communications cables
connected properly?
Solution
Replace with new,
Gerber-approved
material. Store material
in correct environmental
conditions.
Verify or change the
current profile you are
using.
Solution
This is the automatic
dwell operation.
Close out of all other
unnecessary tasks.
Check and reconnect
communication cables as
necessary.
140
Notes
See "Compatible material"
on page 43.
See "Using RIP software
and profiles" on page 75.
Notes
See "UV lamp operations"
on page 75.
See "Pausing a job due to
data starvation" on page
83.
See "Checking network
connections" on page 32.