Installing The Interior - Gerber HS750 Plus User Manual

plus
10 HS750

Installing the Interior

1. Install the roll support bar hole grommets by twisting the
grommet to separate the ends. Press one end into the hole
so that the plastic encases the metal. Work around the
grommet, pressing the plastic over the edge of the metal until
the loose end snaps into place closing the ring.
2. Remove the cover from the control module by removing the
three screws on the front and the two screws on the back.
3. Remove the three screws holding the left end cover of the
plotter and remove the cover. Remove the three screws
holding the right end cover of the plotter and remove the
cover. Save all screws.
4. Mount the plotter on top of the stand assembly. Carefully
align the projecting tabs of the stand with the corresponding
holes in the plotter. Use four #8 pan head screws, four lock
washers, and four flat washers to secure the plotter to the
stand.