Canon G3 Error Code List page 87

##204 [ TX ] DTC was received in the absence of
Cause
• In the case of DTC reception, the proce-
dure signal is faulty.
• When DIS was received during CEP2
transmission, the state of the other party
recognized by the machine and the current
state of the machine do not match.
##205 [ TX ] Error occurred in the data while images
• The image memory is faulty.
transmission data.
When using CEP2 (Canon Express
Protocol 2) for direct transmission, DIS
was received after image transmission, but
there is no transmission data
Remedy
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
• Transmit once again.
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
were being stored in memory
Remedy
• Replace the transmission memory or the
PCB (e.g., system control board) on which
the transmission memory is mounted.
2-27
Chapter 2: Service Error Codes