Canon G3 Error Code List page 132

Chapter 2: Service Error Codes
##342 [ TX/RX ] Ink absorber for cleaning has become full
Cause
• The ink absorber for cleaning has become
full with waste ink.
Remedy
• Turn off and then on the power.
• If the waste ink in the ink absorber is ap-
parently not much, do not replace, but reg-
ister an approximate value once again as
the ink absorber capacity for cleaning in
service mode.
• If the waste ink is much, replace the ink
absorber, and set '0' as ink absorber capac-
ity for cleaning in service mode.
• Replace the printer control board; then,
check the ink absorber capacity, and regis-
ter an approximate value once again as the
ink absorber capacity for cleaning in ser-
vice mode.
• Replace the system control board; then,
check the ink absorber capacity, and regis-
ter an approximate value once again as the
ink absorber capacity for cleaning in ser-
vice mode.
2-72