Canon G3 Error Code List page 152

Chapter 2: Service Error Codes
##674 [ TX ] In V.34 transmission, the procedure fails to
Cause
• In phase 3 or phase 4, the other party can-
not receive the signal correctly, and dis-
connect the line.
• In phase 3 or phase 4, the signal from the
other party cannot be received correctly.
##675 [ RX ] In V.34 reception, the procedure fails to
Cause
• In phase 3 or phase 4, the other party can-
not receive the signal correctly, and dis-
connect the line.
• In phase 3 or phase 4, the signal from the
other party cannot be received correctly.
move from phase 3 or phase 4 to a control
channel or later, causing a T1 time-over
condition
Remedy
• Increase the transmission level
other party may receive the signal correctly.
• Prohibit the V.8/V.34 procedure.
• Ask the operator of the other party to in-
crease the transmission level
signal may be received correctly.
• Prohibit the V.8/V.34 procedure.
move from phase 3 or phase 4 to a control
channel or later, causing a T1 time-over
condition
Remedy
• Increase the transmission level
other party may receive the signal correctly.
• Prohibit the V.8/V.34 procedure.
• Ask the operator of the other party to in-
crease the transmission level
signal may be received correctly.
• Prohibit the V.8/V.34 procedure.
2-92
*1 so that the
*1
so that the
*1
so that the
*1 so that the