Canon G3 Error Code List page 79

##113 [ TX ] After transmitting Q or PRI-Q, a signal other
Cause
• The procedure signal is faulty.
##114 [ RX ] RTN was transmitted
Cause
• The line condition is poor, and the image
signal from the other party cannot be re-
ceived correctly.
• The machine malfunctioned because of an
echo of CFR.
than MCF, RTP, RTN, PIP, or PIN was received
Remedy
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
Remedy
• Ask the operator of the other party to in-
crease the transmission level
image signal may be received correctly.
• Ask the operator of the other party to de-
crease the transmission start speed.
• Adjust the NL equalizer
age signal may be received correctly.
• Loosen the RTN transmission conditions
so that RTN will not be transmitted.
• Provide echo remedy 3
• Decrease the transmission level
an echo of transmitted CFR will not be re-
ceived.
2-19
Chapter 2: Service Error Codes
*1
so that the
*2 so that the im-
*7
.
*6
*1
so that