Canon G3 Error Code List page 84

Chapter 2: Service Error Codes
##200 [ RX ] During image reception, a carrier is not
Cause
• The line condition is poor, and the image
signal cannot be received.
• The training signal cannot be received be-
cause of an echo of CFR, causing a time-
over condition.
##201 [ TX/RX ] DCN was received through a non-normal
Cause
• The other party is not ready for reception
(e.g., out of recording paper).
• The user telephone number has not been
registered (if the receiving machine is a
RICOH 3000L).
• During reception, a talk reservation was
made; however, a call was not answered.
detected for 5 sec
Remedy
• Ask the operator of the other party to in-
crease the transmission level
image signal may be received correctly.
• Ask the operator of the other party to de-
crease the transmission start speed.
• Provide echo remedy 3
• Decrease the transmission level
an echo of transmitted CFR will not be re-
ceived.
procedure
Remedy
• Ask the operator of the other party to set
the machine for reception (as by setting re-
cording paper).
• Register the user telephone number.
• Contact the other party by telephone.
2-24
*1
so that the
*7 .
*1 so that