Canon G3 Error Code List page 190

Chapter 2: Service Error Codes
##796 [ RX ] A fault occurred in decoding process
Cause
• An error was detected when image data re-
ceived normally in ECM communication
was decoded.
• The transmitting machine sent the wrong
image data.
##799 [ TX ] System error
Cause
• When the Canon Express Protocol was in
use, an attempt was made to transmit EOR.
during a communication
Remedy
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
Remedy
• Turn off and then on the power.
• Replace the system control board.
2-130