##300
[ TX ] Interface error occurred between the
Cause
• An internal unit is faulty (i.e., after the fluo-
rescent lamp goes ON, the WAIT signal
does not go OFF for 8 sec while in wait
for a response from the reading block).
##301
[ TX ] Interface error occurred between the
Cause
• An internal unit is faulty (i.e., after pre-
scanning, the WAIT signal does not go OFF
for 3 sec while in wait for a response from
the reading unit).
reader and the controller
Remedy
• Correct it by referring to the Service
Manual of the model in question.
reader and the controller
Remedy
• Correct it by referring to the Service
Manual of the model in question.
2-53
Chapter 2: Service Error Codes