Canon G3 Error Code List page 94
Hide thumbs
Also See for G3:
- User manual (219 pages) ,
- Service manual (185 pages) ,
- Instruction manual (82 pages)
Table of Contents
Advertisement
Chapter 2: Service Error Codes
##232
[ TX ] The unit used to control the encoder is
Cause
• The operation of the IC used to control the
encoder did not end normally.
##233
[ TX ] The unit used to control the CCD is faulty
Cause
• The operation of the IC used to control the
CCD did not end normally.
faulty
Remedy
• Replace the unit used to control the encoder
(e.g., system control board).
Remedy
• Replace the unit used to control the CCD.
2-34
Hide quick links:
Advertisement
Table of Contents
