Definitions Of The Terms And Expressions - Canon G3 Error Code List

DEFINITIONS OF THE TERMS AND EXPRESSIONS

The terms and expressions used in this manual are defined as follows:
1. Transmission Level (ATT): No.07 of Service Soft Switch #2 MENU
Increase the transmission level:
Increase the setting so that it is closer to 0 dBm. (At 0 dBm, the LCD indicates '0'.) Some
models, however, do not allow the setting to be increased to 0 dBm.
Decrease the transmission level:
Decrease the setting so that it is closer to -15 dBm. (At -15 dBm, the LCD indicates '15'.)
2. NL Equalizer: No.05 of Service Soft Switch #2 MENU
Adjust the NL equalizer:
Select 'ON'.
3. Transmission Page Timer: SW12 of Service Soft Switch #1 SSSW
Increase the page timer setting:
To set both transmission and reception to the same time-out length, set SW12 as follows:
8 min:
16 min: bit 7, bit 1, bit 0 = 0, 0, 1
32 min: bit 7, bit 1, bit 0 = 0, 1, 0
64 min: bit 7, bit 1, bit 0 = 0, 1, 1
If you want to set transmission and reception to different time-out lengths, or use different
time-out lengths according to different image modes, you will have to set all bits (from 7
through 0) accordingly. For details, see the G3 Facsimile Service Data Handbook.
4. T0 Timer: No.10 of Service Soft Switch #3 NUMERIC param.
Increase the T0 timer setting:
Increase the setting of No.10.
The T0 timer is used to set the period of time in which a line connection is recognized for
transmission, i.e., in which the machine waits for a significant signal from the other party after
dialing. The line will be disconnected if no significant signal is received during the period.
5. T1 Timer: No.11 of Service Soft Switch #3 NUMERIC param.
Increase the T1 timer setting:
Increase the setting of No.11.
The T1 timer is used to set the period of time in which a line connection is recognized for
reception, i.e., in which the machine waits for a significant signal from the other party after
transmission of DIS. The line will be disconnected if no significant signal is received during
the period.
bit 7, bit 1, bit 0 = 0, 0, 0
V
Introduction