Canon G3 Error Code List page 78

Chapter 2: Service Error Codes
##111 [ TX/RX ] Memory error
Cause
• While printing data stored in the image
memory, the effects of noise caused a data
error.
• Noise started wrong dialing.
##112 [ TX ] DIS has been received 3 times
Cause
• The transmission level is low, and the other
party cannot receive DCS, TCF, or train-
ing signal correctly.
• The other party malfunctioned because of
an echo.
Remedy
• Print out all image data and system data,
and execute all-clear; then, store the sys-
tem data once again.
• Replace the system control board.
Remedy
• Increase the transmission level
other party may receive the signal correctly.
• Adjust the NL equalizer
party may receive the signal correctly.
• Using a manual call, press the Start button
after hearing the 1st DIS from the other
party.
• To prevent response to the 1st DIS from
the other party, put a relatively long pause
to the telephone number when registering
an auto-dialing number.
• Ask the operator of the other party to pro-
vide echo remedy 2
• Ask the operator of the other party to de-
crease the transmission level
other party will not receive an echo.
2-18
*1
so that the
*2
so that the other
*7
.
*1
so that the