Canon G3 Error Code List page 108
Hide thumbs
Also See for G3:
- User manual (219 pages) ,
- Service manual (185 pages) ,
- Instruction manual (82 pages)
Table of Contents
Advertisement
Chapter 2: Service Error Codes
##287
[ TX ] DCN has been received after transmitting
Cause
• The Stop button was pressed during a com-
munication.
##288
[ TX ] After transmitting EOP, a signal other than
Cause
• The procedure signal has a fault.
MPS
Remedy
• Transmit once again.
PIN, PIP, MCF, RTP, or RTN was received
Remedy
• Record the protocol on a DAT or MD, and
have it analyzed by the local Canon office
and/or Technical Center.
2-48
Hide quick links:
Advertisement
Table of Contents
