Canon G3 Error Code List page 266

Chapter 2: Service Error Codes
##1600 [ RX ] Fault occurred in the communication
Cause
• A fault occurred in the communication pro-
cedure for G4 layer 4 or lower in channel
B.
• A fault occurred in the G3 communication
procedure in channel B.
##1601 [ TX/RX ] Fault occurred when a connection was
Cause
• A fault occurred in the parameter (e.g.,
transport length) established by G4 layer
4 in channel B.
• A fault occurred in the G3 communication
procedure in channel B.
procedure
Remedy
• Start a communication once gain.
• Print out a communications analysis list,
and analyze it.
made for communication
Remedy
• Start a communication once again.
• Print out a communications analysis list,
and analyze it.
2-206