Installing The Hot-Swap Power Supply Cage; Removing And Replacing Frus; Removing A Serveraid-Br10Il V2 Sas/Sata Controller - IBM x3200 M3 7327 Service Manual

Installing the hot-swap power supply cage

This procedure applies only to server models that have hot-swap power-supplies.
To install the hot-swap power supply cage, complete the following steps:
1. Place the power-supply cage into the chassis and slide it toward the rear of the
2. Install the four screws that secure the power-supply cage to the chassis.
3. Connect the cables from the power-supply cage to the system board and all
4. Reinstall both hot-swap power supplies (see "Installing a hot-swap power
5. Install the side cover (see "Installing the side cover" on page 146).
6. Lock the side cover if you unlocked it during removal.
7. Reconnect the external cables and power cords; then, turn on the attached

Removing and replacing FRUs

Field replaceable units (FRUs) must be installed only by trained service technicians.

Removing a ServeRAID-BR10il v2 SAS/SATA controller

To remove the mini-SAS/SATA RAID controller, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords
204
System x3200 M3 Types 7327 and 7328: Problem Determination and Service Guide
server until the retaining clips engage the top of the chassis.
internal components (see "System-board internal connectors" on page 16 for the
locations of the internal connectors).
supply" on page 167).
devices and turn on the server.
on page 141.
and external cables.
Note: When you disconnect the power source from the server, you lose the
ability to view the LEDs because the LEDs are not lit when the power source is
removed. Before you disconnect the power source, make a note of which LEDs
are lit, including the LEDs that are lit on the operation information panel and
LEDs inside the server on the system board.