Configuring Etherchannel Load Balancing - Cisco Catalyst 2975 Software Configuration Manual

Ios release 12.2(55)se
Hide thumbs Also See for Catalyst 2975:
Table of Contents

Advertisement

Chapter 37
Configuring EtherChannels and Link-State Tracking
Configuring EtherChannels
This example shows how to configure an EtherChannel on a switch. It assigns two ports as static-access
ports in VLAN 10 to channel 5 with the PAgP mode desirable:
Switch# configure terminal
Switch(config)# interface range gigabitethernet2/0/1 -2
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode desirable non-silent
Switch(config-if-range)# end
This example shows how to configure an EtherChannel on a switch. It assigns two ports as static-access
ports in VLAN 10 to channel 5 with the LACP mode active:
Switch# configure terminal
Switch(config)# interface range gigabitethernet2/0/1 -2
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode active
Switch(config-if-range)# end
This example shows how to configure a cross-stack EtherChannel. It uses LACP passive mode and
assigns two ports on stack member 2 and one port on stack member 3 as static-access ports in VLAN 10
to channel 5:
Switch# configure terminal
Switch(config)# interface range gigabitethernet2/0/4 -5
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode active
Switch(config-if-range)# exit
Switch(config)# interface gigabitethernet3/0/3
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 10
Switch(config-if)# channel-group 5 mode active
Switch(config-if)# exit

Configuring EtherChannel Load Balancing

This section describes how to configure EtherChannel load balancing by using source-based or
destination-based forwarding methods. For more information, see the
"Load Balancing and Forwarding
Methods" section on page
37-8.
Catalyst 2975 Switch Software Configuration Guide
37-15
OL-19720-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents