Table of Contents
Advertisement
2
Making Measurements
Performing Resistance Measurement and Continuity Test
Performing Resistance Measurement and Continuity Test
C A U T I O N
Steps
1 Set the rotary switch to Ω.
2 Connect the red and black test leads to input terminals Ω (red) and
3 Probe the test points (by shunting the resistor) and read the display.
4 To perform continuity test, press Shift once (see
40
Disconnect circuit power and discharge all high-voltage capacitors
before measuring resistance or conductance, or testing circuit
continuity, to avoid damaging the clamp meter or the device under test.
(Figure 2- 3
on page 41):
COM (black) respectively.
page 42). The buzzer will sound when the resistance is below 10.0 Ω.
Figure 2- 4
on
User's and Service Guide
Hide quick links:
Advertisement
Table of Contents
