Setting Data Hold/Refresh Hold Mode; Figure 4-3 Setting The Data Hold Or Refresh Hold Mode - Agilent Technologies U1211A User's Manual And Service Manual

4 Changing the Default Settings
Default Factory Settings and Available Setting Options

Setting Data Hold/Refresh Hold mode

To enable the data hold mode (manual trigger), set this parameter to OFF.
To enable the refresh hold mode (automatic trigger), set the variation
count within the range of 100 to 1000 in a step of 100. Once the variation
of the measured value exceeds this preset variation count, the refresh hold
mode will be ready to trigger and update a new value.

Figure 4-3 Setting the data hold or refresh hold mode

70
Press
Press or to
edit the value at a step
of 100
Press
Press
Press
User's and Service Guide