1
Getting Started
Product at a glance
Using the clamp meter buttons
Figure 1-5 Function and status buttons
The buttons located between the annunciator display and input terminals
have two functions: the primary functions (labels printed above the
buttons) and secondary functions (labels printed below the buttons). The
primary function is accessible by pressing the button momentarily, while
the secondary function is accessible by pressing the button for more than
1 second. Only
Button
28
Primary
functions
Secondary
functions
Description
• Press Shift/Peak momentarily to perform a shifted function. The shifted function is
mostly used with the rotary switch to cycle between measurement functions. See
rotary switch at a glance"
• Press Shift/Peak for more than 1 second to perform Peak function. See
Hold"
on page 59 for more information.
• Press Hz/%/
momentarily to enable frequency measurement on the secondary display
in the annunciator display.
• Press Hz/%/
momentarily again (after enabling frequency measurement) to perform
[1]
duty cycle (%)
function.
• Press Hz/%/
for more than 1 second to enable backlight illumination.
do not have secondary function.
on page 30 for more information.
"The
"1 ms Peak
User's and Service Guide