Setting The Date And Time Explicitly - HP StorageWorks SN6000 Command Line Interface Manual

Setting the date and time explicitly

To set the switch date and time explicitly, use the set timezone and date commands.
1. To change the time zone (to America/North Dakota, for example), enter the set timezone
command in an Admin session, as shown in the following example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> set timezone
Africa
Antarctica
Atlantic
Europe
Pacific
America/Grenada
America/Guatemala
America/Guyana
America/Havana
America/Indiana
.
.
.
America/Monterrey
America/Montreal
America/Nassau
America/Nipigon
America/Noronha
America/Panama
q
Enter selection (or 'q' to quit): america/north_dakota
America/North_Dakota/Center
Enter selection (or 'q' to quit): q
2. To set the date and time (January 31, 10:15 AM, 2008), enter the date command, as shown in the
following example:
SN6000 FC Switch (admin) #> date 013110152008
SN6000 FC Switch (admin) #> date
Thu Jan 31 10:15:03 america/north_dakota/center 2008
48 Switch Configuration
Press ENTER for more options or 'q' to make a selection.
Press ENTER for more options or 'q' to make a selection.
America
Asia
Australia
Indian
UTC
America/Guadeloupe
America/Guayaquil
America/Halifax
America/Hermosillo
America/Indianapolis
America/Montevideo
America/Montserrat
America/New_York
America/Nome
America/North_Dakota
America/Pangnirtung