HP StorageWorks SN6000 Command Line Interface Manual page 147

The following is an example of the firmware install command using TFTP:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> firmware install
The switch will be reset.
to I/O traffic.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
FTP or TFTP
IP Address
Source Filename : 8.0.xx.xx_epc
About to install image.
Connected to 10.0.0.254 (10.0.0.254).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
See also image, page 158
This process will cause a disruption
: tftp
: 10.0.0.254
Do you want to continue? [y/n] y
HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 147