Admin - HP StorageWorks SN6000 Command Line Interface Manual

admin

Description Opens and closes an Admin session. The Admin session provides access to commands that change
the fabric and switch configurations. Only one Admin session can be open on the switch at any time.
An inactive Admin session will time out after a specified period of time, which is changed using the
set setup system command.
Authority User account with Admin authority
Syntax
admin
start or begin
end or stop
cancel
Operands start or begin)
Opens the Admin session
end or stop
Closes the Admin session. The hardreset, hotreset, quit, shutdown, and
reset switch commands will also end an Admin session.
cancel
Terminates an Admin session opened by another user. Use this operand with care because it
terminates the Admin session without warning the other user and without saving pending
changes.
Notes Closing a Telnet window during an Admin session does not release the session. In this case, you
must either wait for the Admin session to time out, or use the admin cancel command.
Examples The following example shows how to open and close an Admin session:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #>
.
.
.
SN6000 FC Switch (admin) #> admin end
set setup
See also
126 Command Reference
system, page 222