Transceiver Information - HP StorageWorks SN6000 Command Line Interface Manual

254 Command Reference
Table 62

Transceiver information

Entry
MediaType
MediaVendor
MediaPartNumber
MediaRevision
MediaSerialNumber
MediaSpeeds
Temp
Voltage
Tx Bias
Tx Power
Rx Power
Value
Status
HighAlarm
HighWarning
LowWarning
LowAlarm
Description
Media physical variant. The variant indicates speed, media,
transmitter, and distance. The media designator may be M5
(multimode 50 micron), M6 (multimode 62.5 micron), or MX.
MX indicates that the media supports both multimode 50 and
62.5 micron.
MediaType may also be one of the following:
• NotInstalled–transceiver is not installed.
• Unknown–transceiver does not have a serial ID.
• NotApplicable–transceiver is not needed.
Vendor name
Vendor media part number
Vendor media revision level
Vendor media serial number
Transmission speed capabilities
Temperature in degrees Celsius
Supply voltage in Volts. The range is 0–6.55.
Transmitter laser bias current in milliamps. The range is 0–655.
Transmitter coupled output power in milliWatts. The range is
0–6.55.
Received optical power in milliWatts. The range is 0–6.55.
Measured value
State associated with the measured value:
Normal: Value is in the normal operating range.
•
• HighAlarm: Value exceeds the high alarm threshold.
• HighWarning: Value exceeds the high warning threshold.
• LowWarning: Value is less than the low warning threshold.
• LowAlarm: Value is less than the low alarm threshold.
Vendor specified threshold above which an alarm is issued
Vendor specified threshold above which a warning is issued
Vendor specified threshold below which a warning is issued
Vendor specified threshold below which an alarm is issued