HP StorageWorks SN6000 Command Line Interface Manual page 215

The following is an example of the set setup radius server command:
SN6000 FC Switch (admin) #> set setup radius server 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
PLEASE NOTE:
-----------
* SSL must be enabled in order to configure RADIUS User Authentication
SSL can be enabled using the 'set setup services' command.
Server 1 Current Values:
ServerIPAddress
ServerUDPPort
DeviceAuthServer
UserAuthServer
AccountingServer
Timeout
Retries
SignPackets
Secret
New Server 1 Value (press ENTER to accept current value, 'q' to skip):
ServerIPAddress
ServerUDPPort
DeviceAuthServer
UserAuthServer
AccountingServer
Timeout
Retries
SignPackets
Secret
Do you want to save and activate this radius setup? (y/n): [n]
See also show setup radius, page 268
10.20.11.8
1812
True
True
False
10
0
False
**********
(hostname, IPv4, or IPv6 address)
(decimal value)
(True / False)
(True / False)
(True / False)
(decimal value, 1-30 secs)
(decimal value, 1-3, 0=None)
(True / False)
(1-63 characters, recommend 22+)
HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 215
:
:
:
:
:
:
:
:
: