HP StorageWorks SN6000 Command Line Interface Manual page 197

Table 33 Port configuration parameters (continued)
Parameter
IOStreamGuard
PDISCPingEnable
(SFP ports only)
Examples The following is an example of the set config port command:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> config edit
SN6000 FC Switch (admin-config) #> set config port 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
SymPortName
ALFairness
DeviceScanEnable (True / False)
ForceOfflineRSCN (True / False)
ARB_FF
InteropCredit
FANEnable
AutoPerfTuning
MSEnable
NoClose
IOStreamGuard
PDISCPingEnable
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
Description
Enables or disables the suppression of RSCN messages.
IOStreamGuard can have the following values:
• Enable—Suppresses the reception of RSCN messages from other
ports for which IOStreamGuard is enabled.
• Disable—Allows free transmission and reception of RSCN
messages.
• Auto—Suppresses the reception of RSCN messages when the port is
connected to an initiator device with a QLogic HBA. For older QLogic
HBAs, such as the QLA2200, the DeviceScanEnabled parameter
must also be enabled. The default is Auto.
Enables (True) or disables (False) the transmission of ping messages
from the switch to all devices on a loop port. The default is True.
1
(1=Online, 2=Offline, 3=Diagnostics, 4=Down)
(1=1Gb/s, 2=2Gb/s, 4=4Gb/s, 8=8Gb/s, A=Auto)
(GL, G, F, FL, TR )
(string, max=32 chars)
(True / False)
(True / False)
(decimal value, 0-255)
(True / False)
(True / False)
(True / False)
(True / False)
(Enable / Disable / Auto)
(True / False)
HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 197
[Online]
[Auto ]
[GL ]
[Port1 ]
[False ]
[True ]
[False ]
[False ]
[0 ]
[True ]
[True ]
[True ]
[False ]
[Auto ]
[True ]