Checking The Firmware Version; Setting The Switch Date And Time; Displaying Switch Configuration Settings - HP StorageWorks 2/16 - SAN Switch Installation Manual

Managing the SAN Switch 2/16

Checking the Firmware Version

Use these steps to display the firmware version.
1. Log in to the switch as the admin user.
2. At the command line, issue the version command.

Setting the Switch Date and Time

All switches maintain current date and time in non-volatile memory. Date and
time are used for logging events. Switch operation does not depend on the date
and time; a switch with an incorrect date and time value still functions properly.
Execute the following procedure to set the date and time of a switch.
1. Log in to the switch as the admin user.
2. At the command line, issue the following command:
Note:
than 70 are interpreted as 2000–2069. The date function does not support daylight
saving time or time zones.

Displaying Switch Configuration Settings

Follow these steps to display the system configuration settings.
1. Log in to the switch as the admin user.
2. At the command line, issue the configShow command.
64
This command displays the Kernel version, and Fabric OS release number.
date "MMDDhhmmYY"
where:
— MM is the month, valid values are 01–12.
— DD is the date, valid values are 01–31.
— hh is the hour, valid values are 00–23.
— mm is minutes, valid values are 00–59.
— YY is the year, valid values are 00–99.
Year values greater than 69 are interpreted as 1970–1999; year values less
The system configuration settings are displayed.
SAN Switch 2/16 Version 3.1.2 Installation Guide