Managing Switch Services - HP StorageWorks SN6000 Command Line Interface Manual

Managing switch services

You can configure your switch to suit the demands of your environment by enabling or disabling a variety
of switch services using the set setup services commands. To display the status of the switch
services, use the show setup services command. See
settings.
IMPORTANT:
enabled, you will be unable to manage the switch using this version of Simple SAN Connection Manager.
To display the current switch services settings, enter the show setup services command, as shown in
the following example:
SN6000 FC Switch #> show setup services
System Services
-----------------------------
Telnet Enabled
SSHEnabled
GUIMgmtEnabled
SSLEnabled
EmbeddedGUIEnabled
SNMPEnabled
NTPEnabled
CIMEnabled
FTPEnabled
MgmtServerEnabled
CallHomeEnabled
42 Switch Configuration
Simple SAN Connection Manager version 1.0 does not support the SSL service. If SSL is
True
False
True
False
True
True
True
True
True
True
True
Table 49 for descriptions of the switch services