HP StorageWorks SN6000 Command Line Interface Manual page 198

The following is an example of the set config port command for an XPAK port:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> config edit
SN6000 FC Switch (admin-config) #> set config port 20
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
SymPortName
DeviceScanEnable (True / False)
ForceOfflineRSCN (True / False)
AutoPerfTuning
MSEnable
IOStreamGuard
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
See also config, page 136
show config
198 Command Reference
20
(1=Online, 2=Offline, 3=Diagnostics, 4=Down)
(10=10Gb/s, 20=20Gb/s,A=Auto)
(G, F)
(string, max=32 chars)
(True / False)
(True / False)
(Enable / Disable / Auto)
port, page 236
[Online]
[Auto ]
[G ]
[20G-20]
[True ]
[False ]
[True ]
[True ]
[Auto ]