Set Setup Snmp; Common Snmp Configuration Parameters - HP StorageWorks SN6000 Command Line Interface Manual

set setup snmp

Description Configures SNMP on the switch.
Authority Admin session
Syntax
set setup snmp
common
trap [trap_number]
Operands
common
Prompts you in a line-by-line fashion to change SNMP configuration parameters that are common
for all traps. For each parameter, enter a new value or press Enter to accept the current value. To
configure common parameters and trap parameters, omit the common operand.
describes the common SNMP configuration parameters.
Table 50

Common SNMP configuration parameters

Parameter
SNMPEnabled
Contact
Location
ReadCommunity
WriteCommunity
TrapCommunity
AuthFailureTrap
ProxyEnabled
SNMPv3Enabled
Description
Enables (True) or disables (False) SNMP on the switch. The default is
True.
Specifies the name of the person to be contacted to respond to trap
events. The name can be up to 64 characters excluding #, semicolon (;),
and comma (,). The default is undefined. This value is also passed to the
Call Home service configuration.
Specifies the name of the switch location. The name can be up to 64
characters excluding #, semicolon (;), and comma (,). The default is
undefined. This value is also passed to the Call Home service
configuration.
Read community password that authorizes an SNMP agent to read
information from the switch. This is a write-only field. The value on the
switch and the SNMP management server must be the same. The read
community password can be up to 32 characters excluding #, semicolon
(;), and comma (,). The default is public.
Write community password that authorizes an SNMP agent to write
information to the switch. This is a write-only field. The value on the
switch and the SNMP management server must be the same. The write
community password can be up to 32 characters excluding #, semicolon
(;), and comma (,). The default is private.
Trap community password that authorizes an SNMP agent to receive
traps. This is a write-only field. The value on the switch and the SNMP
management server must be the same. The trap community password
can be up to 32 characters excluding #, semicolon (;), and comma (,).
The default is public.
Enables (True) or disables (False) the generation of traps in response
to trap authentication failures. The default is False.
Enables (True) or disables (False) SNMP communication with other
switches in the fabric. The default is True.
Enables (True) or disables (False) SNMP version 3. The default is
False.
HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 219
Table 50