Show Alarm - HP StorageWorks SN6000 Command Line Interface Manual

show alarm

Description Displays the alarm log and session output stream display setting.
Authority None
Syntax
show alarm
settings
Operands
settings
Displays the status of the parameter that controls the display of alarms in the session output
stream. This parameter is set using the set alarm command.
Notes The alarm log is cleared when the switch is reset or power-cycled.
Examples The following is an example of the show alarm command:
SN6000 FC Switch #> show alarm
[1][Fri Jan 19 13:50:26.508 UTC 2007][A][1004.000F][Port: 4][Eport
Isolating
due to Merge Zone Failure]
[2][Fri Jan 19 13:50:26.513 UTC 2007][A][1004.0030][Topology change, lost
route to switch with domain ID 1]
[3][Sun Jan 21 07:59:28.677 UTC 2007][A][1004.0030][Topology change, lost
route to switch with domain ID 99]
[4][Sun Jan 21 07:59:29.367 UTC 2007][A][1004.0030][Topology change, lost
route to switch with domain ID 101]
The following is an example of the show alarm settings command:
SN6000 FC Switch #> show alarm settings
Current settings for alarm
--------------------------
display ON
HP StorageWorks SN6000 Fibre Channel Switch Command Line Interface Guide 233