Front Panel I/O Device Assembly; Removing The Front Panel I/O Device Assembly - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Front panel I/O device assembly

This section describes how to remove and install a front panel I/O device assembly.

Removing the front panel I/O device assembly

To remove the front panel I/O device assembly:
1. Disconnect power from the computer (see
2. Remove the access panel (see
3. Remove the front bezel (see
4. Remove the screws that attach the I/O device assembly to the chassis, as shown in the following
figure (1).
5. Swing the assembly into the chassis to release it from the front panel, as shown in the following
figure (2).
Figure 5-33
96 Chapter 5 Replacing components
Removing the access panel on page
Removing the front bezel on page
Disconnecting the front panel I/O device assembly
Predisassembly procedures on page 68
72).
).
71).
ENWW