Clearing Passwords; Chassis Security; Side Access Panel Sensor (Smart Cover Sensor) (Optional); Side Access Panel Solenoid Lock - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Clearing passwords

If you forget the password, you cannot access the computer.
For instructions about clearing passwords, see Configuring password security and resetting
CMOS.

Chassis security

Side access panel sensor (Smart Cover Sensor) (optional)

The optional Side access panel sensor is a combination of hardware and software technology that can
alert you when the computer side access panel has been removed (if the sensor has been configured
in the Computer Setup (F10) Utility).
The three levels of Side access panel sensor protection are shown in the following table:
Table 4-4
Level
Level 0
Level 1
Level 2
* Side access panel sensor settings can be changed using the Computer Setup (F10) Utility.
Setting the side access panel sensor protection level
To set the side access panel sensor protection level:
1. Power on or restart the computer.
2. As soon as the computer is powered on, press and hold the
Setup (F10) Utility. Press
NOTE:
and then press and hold the
If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.
3. Select Security>Smart Cover>Cover Removal Sensor, and follow the onscreen instructions.
4. Before exiting, select File>Save Changes and Exit.

Side access panel solenoid lock

The side access panel solenoid locks the side access panel to the chassis. The solenoid is controlled
by a local or remote signal.
To lock the solenoid, set a password for the solenoid lock in the Computer Setup (F10) Utility. To unlock
the solenoid, remove the solenoid lock password in the Computer Setup (F10) Utility.
The solenoid lock FailSafe Key–available from HP–is is a device for manually disabling the solenoid
lock. You will need the FailSafe Key in case of forgotten password, power loss, or computer malfunction.
56 Chapter 4 System management
Side access panel sensor protection levels
Setting Description
Disabled Side access panel sensor
Notify User When the computer restarts, a message appears indicating that the computer
side access panel has been removed.
Setup Password When the computer is restarted, a message appears indicating that the computer
side access panel has been removed. You must enter the setup password to
continue.
Enter
If you do not press the
* is disabled (default).
to bypass the title screen, if necessary.
F10 key at the appropriate time, you must restart the computer,
F10 key again to access the Computer Setup (F10) Utility.
F10 key until you enter the Computer
ENWW